|
In-die tapping units with removable single or multi-tap head and built-in mobility functions.
The modular tapping solution, easy to integrate and use.
These in-die tapping units are designed with a removable head and may be used for single or multi-tap applications. The tapping head is driven either by mechanical or by servo-driven mtorization. the two-part design simplifies operations and enables quick tap change.
These units have been studied to integrate the commonly installed functions in the die directly and compactly in the tapping head.
According to the proposed version, the turnkey "TK" solution integrates the following functions:
- Strip guiding,
- Vertical strip follow (strip lift)
- Quick approach of the tapping head and strip piloting.
This made-to-measure turnkey solution is adapted to your die environment:
- The tapping station kinematics are totally controlled
- The tapping station design is simplified and quick to implement
- The tapping station tooling costs are significantly reduced.
|
 |
 |
 ADVANTAGES :
-
Simple integration of the device in the die
-
Reduced tapping station tooling costs: design and assembly of the tapping station is rapid and implementation is less expensive.
- The kinematics are totally controlled: full guarantee of opertation and optimized tapping speed.
- The rates are optimal: tapping begins just after the strip feeding, before the stripper contact.
- Use is simplified: no specific tooling, tapping head and motorization guaranted by indexing pin, lightweight head to simplify handling.
- The range is modular: several possible configurations, motorization can be shared on several dies.
- The motorization is simplified and standardized.
|
 |
|
|
|
 |
|
Replace tap quickly
PRONIC tapping units use standard rollforming taps, which you can find at your local industrial products supplier or direct from PRONIC for high quality taps.
Tap change is made quickly after the head has been removed out of the die.
The standard tooling necessary for tightening the tap is provided by PRONIC.
|
|
|
|
|
|
|
Slide the tapping head In/out of the die in seconds
|
|
 |
|
Installation of the tapping head into the die is very simple. Only one hand needed to lock and unlock. Position guaranteed by an indexing pin.
|
|
|
|
Slide the motorization
In/out of the die few moments
|
|
 |
|
The motorization is installed in the die in a few moments. Position guaranteed by an indexing pin. The groove shaft easily disengages from the head.
|
|
 |
|
Tapping Units
Download the PDF brochure :